• Copper Wire Turns Red or Black After Drawing

Possible Causes:

Drawing fluid pH is too low (< 8.0)
Insufficient BTA concentration

Corrective Actions:

Increase the pH by adding TEA, then replenish BTA as required.

  • Sedimentation and Nozzle Blockage

Possible Causes:

BTA may precipitate at the bottom of the system due to insufficient solubility.

Corrective Actions:

Pre-dissolve BTA using TEA and hot water to prepare a concentrate before adding it to the wire drawing system.

  • Drawing Fluid Odor and Loss of Corrosion Protection

Possible Causes:

Bacterial growth in water-based drawing fluids may lower the pH value and reduce corrosion protection performance.

Corrective Actions:

Monitor pH regularly and use an appropriate biocide together with TEA supplementation when necessary.

  • Localized Pitting Corrosion on Copper Wire Surface

Possible Causes:

Poor water quality used for make-up water or solution preparation. Chloride ions (Cl⁻) in hard water may damage the protective film.

Corrective Actions:

Use deionized water (DI water) or purified water when preparing concentrates and replenishing the wire drawing system.

Related Links